Original Operating Instructions
Dokamatic lifting strap 13.00m
3
999265002 - 12/2017
Strap shoes
Depending on the usage situation, the strap shoes of
the lifting strap may need to be dismounted or
remounted.
Dismantling
➤
Remove the linch pin.
➤
Pull out the fixing pin.
Assembly
➤
Remove the fixing pin and linch pin from each strap
shoe.
➤
Mount the strap shoes onto the lifting sling, one after
the other, in the correct location.
➤
Fix them in place with the fixing pin and linch pin.
General remarks
➤
Observe the following points before lifting!
A
Linch pin
B
Fixing pin
Fit the pin and linch pin back onto each strap
shoe, and store the strap shoes safely so that
they can be re-used.
C
Lifting sling
D
Straight side
E
Elbowed plate
Make sure that the strap shoes are correctly
positioned on the lifting strap:
▪
The straight sides must be facing one
another.
▪
The elbowed plate must be facing
upwards.
WARNING
➤
Strap shoes may only be mounted to original
Doka lifting slings (Dokamatic lifting strap
13.00m).
A
B
9265-200-01
9265-200-02
D
E
C
NOTICE
▪
Suspend the load symmetrically (centre-of-
gravity position).
▪
The lifting sling must always be looped all
the way around the load.
▪
Make sure that the Lifting strap is carefully
and cleanly arranged!
▪
The table elements must be onloaded and
off-loaded, transported and stacked in such
a way that it is not possible for them to fall
off, slip, tip over or slide apart.
▪
Table elements may only be set down and
stacked on flat, firm surfaces.
▪
Spread-angle β of slinging chains: max.
30°.
▪
Do not detach a table element from the lift-
ing straps until it has been safely set down.
▪
Never climb onto the stack of table ele-
ments.
WARNING
➤
Arranging the strap on one side only is
extremely dangerous and so is
FORBIDDEN!
9767-265-02
9265-205-01
