Original Operating Instructions
Dokamatic lifting strap 13.00m
5
999265002 - 12/2017
Lifting single tables
The integrated
strap shoes
are
not
pushed onto the
secondary beams. This makes it possible to operate
the Lifting strap 13.00m when working from ground
level.
The strap shoes can either remain on the strap, or be
detached from it as needed.
e ... approx. 1.0 cm
Declaration of Conformity
B
Strap shoes
NOTICE
It is only allowed to lift
one
table at a time in
each crane cycle!
WARNING
Risk of intermediate props dropping out
when table is lifted
➤
Intermediate props
with a Supporting head
H20 DF, and props that are only secured
against tipping over, must be
removed
before the table is lifted.
➤
Intermediate props that are attached by an
Intermediate head DF
and that are not dis-
mounted must be pulled in sufficiently far.
WARNING
➤
"Passenger transportation" is forbidden!
➤
Before repositioning the tableform, remove
any loose items (e.g. fitting-boards) from it.
➤
Check the connections between the floor
props and the table before repositioning it.
9265-204-01
B
9767-265-01
NOTICE
Tables with pre-mounted edge strips or
covered in sheeting across entire width.
A nailed-on plank (approx. 15 x 5 x 60
cm) pre-
vents the lifting strap damaging or breaking off
the edge strip.
A
Dokamatic lifting strap 13.00m
C
Edge strip
D
Plank
EC Declaration of Conformity
pursuant to EC Directive 2006/42/EC.
The manufacturer declares that by reason of its conception and
design, the following product
Dokamatic lifting strap 13.00m, Art. n° 586231000
Dokamatic lifting strap 13.00m
SN, Art. n° 586231500
conforms – in the version marketed by ourselves – to the pertinent
fundamental health and safety stipulations of the relevant EC Direc-
tives.
The following harmonised standards were applied:
▪
EN ISO 12100:2010
▪
EN ISO 12100-2:2009
▪
EN 349:1993+A1:2008
▪
EN 1492-1:2000+A1:2008
Person authorised to compile technical documentation
(pursuant to European Directive on Machinery Annex
II):
Dipl.-Ing. Ludwig Pekarek
Josef Umdasch Platz 1
A-3300 Amstetten
Amstetten, 06/11/2017
Doka GmbH
Josef Umdasch Platz 1
A-3300 Amstetten
Ludwig Pekarek
Executive Manager
Dipl.-Ing. Peter Reisinger
Authorised Officer, Head of Engi-
neering
9767-280-01
e
A
C
D
