8
5. FIRST USE
STOP
STOP
7
8
4
5
6
1
2
3
Set bar display to maximum level with volume
selector. Push selection lever to the “COLD”
position. Machine starts rinsing.
Switch on machine. Power button starts
blinking red while machine is heating up for
approximately 40 seconds. Afterwards power
button lights steady green. Machine is ready
to use.
Wait until the lever moves to the “STOP” posi-
tion. Extraction stops. Power button blinks red
for about 5 seconds.
Wait until the lever moves to the “STOP” posi-
tion. Open locking handle. Pull out capsule
holder. Remove rinsing tool. Reinsert capsule
holder.
Push selection lever to the “HOT” position.
Machine starts rinsing.
Empty container. Fill water tank with fresh
drinking water. Insert water tank into machine.
Place drip grid on drip tray. Then insert drip
tray at desired position.
Open locking handle. Make sure that rinsing
tool is in capsule holder and capsule holder
is in machine. Close locking handle. Place an
empty large container underneath the coffee
outlet.
Ensure to use the correct mains voltage as given
in “OVERVIEW“. Connect power plug to mains
power socket.
Rinse water tank manually with fresh drinking
water. Fill water tank with fresh drinking water.
Insert water tank into machine.
9
