115
115
6.5
Wiring
Cables of different classes should not be installed in parallel, please obtain a min distance of
20 cm between different cable classes.
Class 1:
Radio, aerial wires (aerial extension wires)
Class 2:
Wires for power supply of the single enclosures
Class 3:
Wires for motors, controls, etc.
The ideal solution is to install each cable class in its own cable duct. If only one cable duct is
available the different class cables should be install wit max. possible distance.
Attention:
The electrical connection of the power supply must be installed in a way that with de-
activation of the main power switch also the BI 5910 is de-activated.
Make sure, that no inductances are created by wiring the charger that could damp the radio
signal of the remote control when it is put into the charger. Make sure that all cables are wired
at the bottom side of the charger.
6.5
Wiring
Cables of different classes should not be installed in parallel, please obtain a min distance of
20 cm between different cable classes.
Class 1:
Radio, aerial wires (aerial extension wires)
Class 2:
Wires for power supply of the single enclosures
Class 3:
Wires for motors, controls, etc.
The ideal solution is to install each cable class in its own cable duct. If only one cable duct is
available the different class cables should be install wit max. possible distance.
Attention:
The electrical connection of the power supply must be installed in a way that with de-
activation of the main power switch also the BI 5910 is de-activated.
Make sure, that no inductances are created by wiring the charger that could damp the radio
signal of the remote control when it is put into the charger. Make sure that all cables are wired
at the bottom side of the charger.
Summary of Contents for BI 5910
Page 129: ...129 129 Appendix Appendix...
