77
77
If the identity codes are different, the remote control
indicates this by a 3 pulse flashing code on it’s both LEDs.
In this case please follow the programming routine
described under 3.9.4
RE 5910
Identity code stored
in remote control RE 5910
Identity code stored
in electronic key
3.5
Electronic key
Defective remote control
It is possible to take the key from an defective remote
control and put it to a
spare one with the same push
buttons as on the defective one.
If the buttons are different they cannot be operated. Then
the Identity code of the key has to be programmed into
the spare remote control. See programming routine 3.9.4
Lost electronic key
A new key RE 5910/02_ can be ordered by stating the
following details:
- 6-figure number of the old key (you should have noted
this number on page 2 of this manual)
- Number of actually used frequency channel on
RE 5910 (01 – 64)
- Time interval of activity monitoring (01 – 99 seconds
or 01 –98 minutes).
With this information you will get an identical new key
with all the parameters of your remote control.
The remote control can be operated when:
Identity code RE 5910 = Identity code electronic key
If the identity codes are different, the remote control
indicates this by a 3 pulse flashing code on it’s both LEDs.
In this case please follow the programming routine
described under 3.9.4
RE 5910
Identity code stored
in remote control RE 5910
Identity code stored
in electronic key
3.5
Electronic key
Defective remote control
It is possible to take the key from an defective remote
control and put it to a
spare one with the same push
buttons as on the defective one.
If the buttons are different they cannot be operated. Then
the Identity code of the key has to be programmed into
the spare remote control. See programming routine 3.9.4
Lost electronic key
A new key RE 5910/02_ can be ordered by stating the
following details:
- 6-figure number of the old key (you should have noted
this number on page 2 of this manual)
- Number of actually used frequency channel on
RE 5910 (01 – 64)
- Time interval of activity monitoring (01 – 99 seconds
or 01 –98 minutes).
With this information you will get an identical new key
with all the parameters of your remote control.
The remote control can be operated when:
Identity code RE 5910 = Identity code electronic key
Summary of Contents for BI 5910
Page 129: ...129 129 Appendix Appendix...
