92
92
3.9.4
Copy of identity code from electronic key
to remote control RE 5910
Please follow this instruction if a maintenance
remote control should be used, or the
electronic key has been exchanged.
Note:
To operate the radio controlled system it is
absolutely necessary the the identity codes of
the remote control, the electronic key and the
BI 5910 are identical.
If using a maintenance remote control or if the
electronic key has been exchanged it is
important to transfer the information from the
electronic key into the remote control RE 5910.
Requirements for this procedure:
The key configuration of the replacement
remote control must be identical with the
configuration stored in the electronic key (or
of the original remote control).
1. Disconnect the multifunction safety module
BI 5910 with radio control
2. Insert the electronic key into the remote
control
3. Keep the buttons B2and start pressed,
- Release the e-stop button (pic.1),
- Release buttons B2 and start
Both LEDs of the remote control RE 5910
flash fast.
4. Press the start button to begin the automatic
programming of the identity code. Both
LEDs of the remote control go OFF (pic.2).
5. The information “Identity code” is copied
from the electronic key into the remote
control (pic.3).
6. Leave the programming mode for identity
code by pressing e-stop. (Pic.4).
It could be necessary to reprogram the radio
frequency(e.g. if the new key was programmed
to a different frequency). In this case please
follow the instructions under 3.9.2.
3.9.4
Copy of identity code from electronic key
to remote control RE 5910
Please follow this instruction if a maintenance
remote control should be used, or the
electronic key has been exchanged.
Note:
To operate the radio controlled system it is
absolutely necessary the the identity codes of
the remote control, the electronic key and the
BI 5910 are identical.
If using a maintenance remote control or if the
electronic key has been exchanged it is
important to transfer the information from the
electronic key into the remote control RE 5910.
Requirements for this procedure:
The key configuration of the replacement
remote control must be identical with the
configuration stored in the electronic key (or
of the original remote control).
1. Disconnect the multifunction safety module
BI 5910 with radio control
2. Insert the electronic key into the remote
control
3. Keep the buttons B2and start pressed,
- Release the e-stop button (pic.1),
- Release buttons B2 and start
Both LEDs of the remote control RE 5910
flash fast.
4. Press the start button to begin the automatic
programming of the identity code. Both
LEDs of the remote control go OFF (pic.2).
5. The information “Identity code” is copied
from the electronic key into the remote
control (pic.3).
6. Leave the programming mode for identity
code by pressing e-stop. (Pic.4).
It could be necessary to reprogram the radio
frequency(e.g. if the new key was programmed
to a different frequency). In this case please
follow the instructions under 3.9.2.
Summary of Contents for BI 5910
Page 129: ...129 129 Appendix Appendix...
