29
UH 5947 / 25.03.19 en / 091A
OA5947/100:
Connection cable for copy function and
adaptor
KY5947 H1/S1:
15 pole adaptor to connect an encoder or
for controllers of Siemens /Heidenhain with
corresponding PIN arrangement
(see remarks for accessories in operating
manual)
KY5947 H2/S4:
25 pole adaptor to connect an encoder or
for controllers of Siemens /Heidenhain with
corresponding PIN arrangement
(see remarks for accessories in operating
manual)
Accessories
Failure
Potential cause
LED "SF" ON
- external failure
(detailed description on display)
LED "Device" ON red
- Device failure
(if the failure still exists after restart,
replace device)
LED "Device" flashes red
- Parameter failure
(min. one adjusted frequency to be
monitored is out of range)
Troubleshooting
When faults are detected on or in the device they are indicated on the
display by an appropriate message. If a reset of the device is necessary
due to the fault, at first the alarm and the associated diagnostic message
have to be acknowledged. Then, the left key has to be pressed for approx.
3 sec. to initiate a reset of the device.
If a system failure is detected again after restart the device must be re-
placed and sent back to manufacturer.
- The device contains no parts that require maintenance.
- In case of failure, do not open the device but send it to manufacturer for repair.
M10374
R
Automatic operation
80 - 100 m/min
Standstill
< 10 m/min
Fault Handling
Maintenance and Repairs
quadratic total current limit curve
0
0
20
40
60
80
100
10 20 30 40 50 60
I (A )
2
2
T ( C)
°
I = I + I
2
2
2
+
I + I
2
2
I , I ,
- Strom in den Kontaktpfaden
I , I
1
1
2
3
4
2
3
4
M10484
Max. zulässiger Strom bei 60°C über
4 Kontaktreihen = 2A = 4x2 A = 16A
2 2
2
^
16 A
2
Characteristics
Summary of Contents for SAFEMASTER S UH 5947
Page 4: ...4 UH 5947 25 03 19 de 091A ...
Page 20: ...20 UH 5947 25 03 19 en 091A ...
Page 36: ...36 UH 5947 25 03 19 fr 091A ...
