BC 950
User Manual
www.dolphindispensers.co.uk
(1)USER'S GUIDE
PLEASE REFER TO THE " CONSTRUCTION DIAGRAM" & " PARTS LIST" in the reverse side.
A. Battery operated DISPENSER. Use "C" type ALKALINE BATTERY 1.5V, 3pcs
B. DIMENSION of DISPENSER 262(H) X 108(W) X 105(D) mm.
C. CAPACITY OF
(no.9) 800CC
D. BATTERY LIFE: 10,000 cycles or 1 year.
E.
AS SOON AS POSSIBLE.
G. If the DISPENSER does not work, please refer to the I
and check the following points.
G1 Is there enough LIQUID SOAP?
G2 Is the BATTERY charged? (no.6)
G3 Is there another object obstructing the SENSING RANGE?
G4 Are the
(no.10), the
(no.11) and the
(no.12)
in the correct position?
G5 Has the
(no.8) been removed?
G6 SENSING RANGE. The SENSING RANGE should be at 6 cm for HANDS ( not for DISHES).
Please use a
to turn the
(no.2)
CLOCKWISE TO INCREASE THE SENSING RANGE
COUNTER CLOCKWISE TO REDUCE THE SENSING RANGE
H. If you would like to remove the DISPENSER. Please
and
to stop dispensing.
I. BEST DESIGN
You can remove and rinse the container assembly if parts numbered 9, 10,11 or 12. are blocked by something.
CONTAINER
NSTALLATION GUIDE
PLASTIC PIPE CONNECTORS
PLASTIC PIPE
NOZZLE
LID
ADJUSTER OF SENSING RANGE
SENSING RANGE
6CM
HANDS
DISHES
POWER TURNS ON AUTOMATICALLY AFTER THE HOUSING (no.7) IS CLOSED.
THE MANUFACTURER HAS FIXED THE
AT
FOR
( NOT FOR
)
You'd better not change the sensing range.
F. INDICATOR GREEN SIGNAL LIGHT. It means "
" & "
"
IN USE
DISPENSING
FLASHING RED SIGNAL LIGHT. It means
To remind you to change the BATTERY
BATTERY ARE LOW.
tiny little screw driver
take out the battery
put the
LID on the container tighly
POWER TURNS OFF AUTOMATICALLY AFTER THE HOUSING (no.7) IS OPENED.
(PLEASE REFER TO THE "CONSTRUCTION DIAGRAM" & "PARTS LIST" on the reverse side.)
Please proceed the following procedures to install the AUTOMATIC SOAP DISPENSER.
A Nothing is allowed within 20 cm from the NOZZLE (no.12)
B Two options for installation.
B1 Hang the DISPENSER. You can find two holes (no.13) on BACK PLASTIC PLATE (no.14) or
B2 Stick on the wall.
By using the prepared
on the
(no.14)
.
rubberized fabric
BACK PLASTIC PLATE
Warning: Clean the wall before you stick the dispenser.
.
AFTER 10 HOURS. Please continue the following procedures if you’re using the second method.
C. Check the
(no.6)
Are the batteries new and powerful enough? ( Use "C" type ALKALINE BATTERIES 1.5V, 3 pcs.)
Are the batteries installed correctly?
D. Two options for liquid soap:
D1: Remove the
(no.9).
can be replaced by
(You can find and purchase it from the supermarket) or
D2: Remove the
(no.8) only, then fill the liquid soap into the
(no.9)
Warning: The viscosity of liquid soap must be: 1 ~ 3,000 cps. It is normal liquid soap,
(You can find it in the supermarket.)
After procedure "D2", please throw away the
(no.8)
Or, if you want to put the
(no.8) on the
(no.9), please don't turn the
too tightly, because flowing air is necessary inside the
(no.9) for dispensing.
E. Check the parts numbered 10, 11, 12 to make sure their positions are correct.
F. Check the SENSING RANGE. The manufacturer has fixed the SENSING RANGE at 6 cm for HANDS (not for
DISHES). Please don’t change the SENSING RANGE.
BATTERY ASSEMBLY
CONTAINER
CONTAINER
SOAP CARTRIDGE.
LID
CONTAINER
LID
CONTAINER
CONTAINER
LID
LID.
(2)INSTALLATION GUIDE
