6
02.4011 User Manual
www.dolphinsolutions.co.uk
Key Description Qty
1 Blower housing - Upper 1
2 Motor rubber – Upper 1
3 Motor brushes 2
4 Motor 0.67HP@240Vac 1
5 Heater assembly 500W@240Vac,115.2
Ω
1
6 Blower housing – Lower 1
7 Motor rubber – Lower 1
8 Base plate 1
9 Grounding screw with cup washer 1
10 Mylar shield with LNG marked 1
11 Nylon cable clamp 1
12 Terminal block 1
13 Blower mounting bracket 1
14 Circuit Board Module (CBM) 1
15 Sensor bracket 1
16 Sensor module 1
17 Label, circuit diagram 1
18 Cover 1
Key Description Qty
19 CAUTION label 2
20 Security hex cap head ¼”-20 x 5/8”
screw with lock washer 1
21 Cable protector 1
22 Screw M4 x10, Philips pan head 2
23 Self threading screw M4 x 10,
Philips pan head 8
24 Screw M3 x 16, Philips pan head 2
25 Screw M4 x 10, Philips pan head
with external tooth lock washer 1
26 Screw M5 x 8, Philips pan head
with external tooth lock washer 2
27 Screw M5 x 10, Philips pan head 2
28 Wire Harness (Not shown) 1
29 L-Wrench 1
30 CBM terminal legend label 1
31 Rating label 1
32 Caution Branch Circuit Label 1
7.5A-240Vac/277Vac
Air Speed:
Switch power off. Loosen cover screws
and remove cover. Use small Philips head
screwdriver to turn VR shaft. Clockwise
to increase power to max. Counter
clockwise to reduce power.
Heater:
Switch power off. Loosen cover screws
and remove cover. Adjust the heater
switch on the PCB with a small plastic or
wood flat blade probe.
Heater on = “ON”
Heater off = “1”
Factory Set Sensor:
Adjustable range 100-230mm
Clockwise to increase range
Counter clockwise to decrease range
Do not overturn!
REPAIR PARTS LIST TO HAND DRYER
