Dolphin BC2009, Operating Instructions And Parts Manual

3

Operating Instructions and Parts Manual 

Hand Dryer

Installation

Surface-mounted high speed hand dryer 

Fix  the  base  plate  to  the  wall  with 
4 screws of 1/4" x 1-1/2" dimension.

Remove and retain 2 cover screws
and cover.

    Connections:
    A. Connect the live wire (colored black, brown or dark)
        to the terminal block marked "L".
    B. Connect the neutral wire (colored white, blue or light)
        to the terminal block marked "N".
    C. Connect the ground wire (colored green or green and yellow)
        to the green screw marked "    ". 
         

1. Make sure power supply breaker is switched off. Installation must be carried out in 
    accordance with the current edition of the local wiring regulations code having 
    jurisdiction. Installation should be performed only by a qualified electrician.
2. Place template against wall at desired height (see mounting height recommendations)
    and mark locations of 4 mounting holes and wire service entry at knockout (KO) location.
    

Note: 

For two or more dryers,  dryers should be no closer than 24 inches (610 mm) 

on center.  

1

4

Insert the power cord into the 
opening.

2

Put the front cover back and screw 
it with L key.

5

Connect the wire into terminal as below:

3