![background image](http://html1.mh-extra.com/html/dolphin/ixh610/ixh610_user-manual_2517432012.webp)
IXH610 Users Guide
– Dolphin Interconnect Solutions
Page 12
DIP switch bank SW 1 - SWMODE
This DIP should normally be kept in factory default mode.
These DIP switches are used to directly control the
PES24NT6G2 Software MODE. Please refer to the
PES24NT6G2 data sheet for details. The most useful options
are documented in the table below.
Binary value
– SWMODE [3:0]
Description
0000b
Single partition, no EEPROM configuration. Supports default
transparent configuration
– non optimized settings. No LEDs
operational. This setting can be used to as an emergency setting if an
incorrect or corrupted EEPORM content prevents the system from
booting. Supports reprogramming of the EEPORM.
1100b
Default setting. Configuration data in EEPROM.
Illustration 7: SW1
– SWMODE - Default setting
Picture 3: DIP Switch SW1 location