Remote Unit
Wave Home Screen
Keyboard Buttons
To start a pool cleaning session directly after you have assembled your
Dolphin Wave, proceed as follows:
1.
Lift the MMI's protective cover.
2.
Connect the robot's power supply to the main power supply line.
3.
Switch on the power supply. The MMI's
Wave
screen (figure 9) opens in the
home window.
4.
Position the Caddy with robot about 0.5–1.0m (1.5-3ft) from the pool's edge
with its sloping edge facing the swimming pool ensuring that the floating cable
is facing the direction of the Dolphin Wave power supply unit.
5.
According to the pool's size, release the appropriate length of cable.
Starting the First Cleaning Session
1.
On the MMI, press
POOL.
The robot starts moving towards the pool and enters
the swimming pool positioning itself on the pool floor.
2.
Wait for the
Wave
screen to appear.
3. In every activation of the robot, it will straighten itself vertically to the wall of the
starting point; the robot will start moving backwards to straighten itself and then
will continue in straight lines.
4.
Press
Start
. "Please select pool length" will appear on the screen.
After 2 seconds the
Pool Length Setup
screen appears.
5.
Using the arrows
select the required pool length. Press
Set
.
6.
Press
Start
. The cleaning session will begin. The factory default settings are
used. In order to change parameters refer to
Configuring Additional Pool
Profiles
on page 12, Operating Instruction Booklet.
Summary of Contents for Wave 300 XL
Page 1: ......
