74
75
Remove the old locking
cylinder if necessary (not il-
lustrated).
Carefully remove Pro cylin-
der with pre-assembled
outside knob from the
packaging.
Align the cam flush with the
cylinder body.
Carefully slide Pro cylinder
through the fitting with the
side without reading knob
forwards.
Hold authorised transpon-
der in front of the outside
knob if necessary, in order
to engage the cam and align
the Pro cylinder.
Fix the Pro cylinder with
the screw as soon as you
feel the correct position. Do
not completely tighten the
screw yet.
Slide the electronics holder
accurately onto the cou-
pling shaft until it reaches
the end position.
Secure the electronics with
the fixing bracket.
Fig. 18: Align cam
3
4
5
6
7
8
Fig. 19: Insert the Pro cylinder
9
Fig. 20: Mount electronics holder
Please note: The battery
connector has a torsion-re-
sistant guide lug.
Insert the battery connector
of the battery pack which
has already been fitted into
the battery socket.
Caution: Do not damage the battery cable when fit-
ting the knob.
Place the knob tool on the
bayonet fitting.
Slide the knob sleeve ac-
curately over the electronics
holder. The knob sleeve can
only be slid on in one posi-
tion. The two drive cams on
the electronics holder have
different widths.
Use a knob tool to turn the
bayonet fitting anti-clockwi-
se, thus locking it.
Check that both knobs turn
freely without scraping on
the fitting.
Tighten the screw.
Please note! Keep the original packaging so that
you can store the Pro cylinder safely at any time.
Fig. 21: Connect battery
10
14
15
11
12
Fig. 22: Side on knob sleeve
13
Fig. 23: Locking the bayonet fitting
