78
79
Slide the electronics holder
accurately onto the cou-
pling shaft until it reaches
the end position.
Secure the electronics with
the fixing bracket.
Please note: The battery
connector has a torsion-re-
sistant guide lug.
Insert the battery connector
into the battery socket.
Place the knob tool on the
bayonet fitting.
Slide the knob sleeve ac-
curately over the electronics
holder. The knob sleeve can
only be slid on in one posi-
tion. The two drive cams on
the electronics holder have
different widths.
Fig. 27: Mount electronics holder
8
Lock the bayonet fitting
using the knob tool.
Check that both knobs turn
freely without scraping on
the fitting.
Tighten the screw.
Please note: Keep the original packaging so that
you can store the cylinder safely at any time.
13
12
Fig. 30: Locking the bayonet fitting
9
Fig. 28: Connect battery
10
11
Fig. 29: Side on knob sleeve
14
PRO HALF CYLINDER
Please note: Ideally, the door with fitting should
be a little thinner than the cylinder body of the Pro
cylinder, so that the knob does not scrape on the fit-
ting and operates smoothly. The cylinder must not
project from the fitting more than 3 mm.
Measure thickness of the
door with lock housing.
Ensure that the basic length
of the Pro cylinder is adap-
ted to the measured thick-
ness.
1
2
Fig. 31: Measure the thickness
