84
85
Hold the Master Card directly in front of the reading knob:
The green LEDs flash twice briefly and once long. The reading
knob then indicates its initialisation by means of the signal se-
quence red, green, yellow, blue and violet. Finally, the red LED
lights up twice briefly and once long.
With the Pro cylinder readable on both sides, repeat the operati-
on on the other reading knob.
Please note: With the Pro cylinder readable on both
sides, programming is independently carried out on
each knob. The authorisation of the locking media
can be programmed differently on the two sides.
Now you can use the Master Card to set up Programming Cards
which you can use in turn to set up locking media.
Please note: The master and Programming Cards
do not function as locking media.
Master Card
The Master Card has the following functions:
- Initialisation of the Pro cylinder
- Setting the engagement time
- Set-up or deletion of individual locking media and
programming media (Programming Cards)
- Simultaneous deletion of all locking media and
programming media (Programming Cards, software solutions)
Programming Card
The Programming Card has the following functions:
- Set-up or deletion of individual locking media
- Deletion of all locking media
Locking medium (key fob, Clip Tag, card, etc.)
- Locking and opening
OPERATION
Programming with Master or Programming Card is performed on
each reading knob. All events which take place during program-
ming are stored at the respective reading knob. If a locking medi-
um is held in front of one of the reading knobs of the Pro cylinder
readable on both sides, the status message only occurs on this
reading knob.
STATUS MESSAGES
In general, if one of the time windows specified in the various
programming modes (removal or presentation of Master or Pro-
gramming Card and locking medium) is not observed, a termina-
tion occurs. Such a termination is acknowledged by two flashes
of the red LED.
ACKNOWLEDGEMENT OF
TERMINATIONS
Time interval not observed
To open or lock the door, you must only hold an authorised lo-
cking medium a short distance in front of the relevant knob.
Authorised transponder:
OPENING AND LOCKING
...
The Pro cylinder is engaged and the green LED flashes during the
set engagement time. Once the clutching time has expired, the
red LEDs flash once.
Unauthorised transponder:
The Pro cylinder is not engaged. The red LEDs flash four times.
