Assembly / Insertion of the cylinder core into cylinder body
24
Insertion of the cylinder core into cylinder body
Caution! Please make sure that the cylinder body is filled with the appro-
priate pins and springs before you insert the filled cylinder core into the
body. To prevent a fall out of core pins please use a soft pad. If neces-
sary, rotate the body as illustrated in fig. 16 to avoid that the profile pins
will fall out of the core. When assembling
cylinder type KL
, please fol-
low the instructions beginning on page 34. When assembling
type 555
,
please follow the instructions beginning on page 39. When assembling
type 382
, please follow the instructions beginning on page 37.
Fig. 16: Core into body
1. Carefully insert the core with the key
channel upwards into the cylinder
body.
Fig. 17:
Remove assembly clam and
turn core
2. Please protect the core from fall out
and remove the assembly clam.
3. Please turn the cylinder core until the
pins fall into the respective borings.
Caution! The cylinder core is not yet fixed by security rings. If you insert
the key the core may be pulled out from the body again and the pins will
fall out. In such an event core and body have to be completely re-filled.