Sigma Plus
Assembly / Type 333
25
Type 333
This chapter describes the assembly of the cam with coupling for type 333.
Requirements: 2 matching keys, 1 coupling (502154), cam (218228 008), 2 security
rings (202335F) for the cam, security ring (202335F) for each extended side (op-
tional), 1 pliers (263629) for the cam, 1 pliers (261669) for the extension piece (op-
tional).
Caution! The cylinder cores are not yet fixed by security rings. If you in-
sert the keys the cores may be pulled out completely from body again
and the pins will fall out. In such an event cores and body have to be
completely re-filled.
Fig. 18: Placing cores
1. Please insert a matching key on both
sides.
2. Please turn key gently.
3. Please pull out cylinder cores to such
an extent until cores or core exten-
sion pieces provide a flush fit inter-
nally with the cylinder body.
Fig. 19: Insertion of cam with coupling
4. Please insert the coupling accurately
fitting into the cam.
5. Please insert the cam with coupling in
the centre of the cylinder body.
6. Please hold the cam in such a posi-
tion that it provides flush fit with the
cylinder body at top and overlaps lat-
erally a little at the bottom.