REV 1 – 26 08 19 Fabriqué en Chine
Page 29
1- Fit the rear grille by correctly
positioning the pins. The hole for the
security screw must be at the bottom.
Then screw the grille tightening nut.
2- Mount the propeller on the motor
shaft by inserting the notches in the
impeller on the pin that passes
through the motor axle, then screw
on the impeller nut. This nut is
tightened
by
turning
it
counterclockwise. After tightening,
check that the impeller rotates freely
by turning it by hand.
3- Fix the plastic disc on the front
grille with the 3 small screws (if it is
not already fixed). Open the 4 safety
clips on the front grille. Place the top
clip of the front grille on the top of the
back grille. Close the 4 safety clips
and check that the 2 grilles are tight
and secure. Fix the small security
screw on the 2 grilles (at the bottom
of the grilles)
Impeller
Oscillation
control
Rear grille
Front grille
Screw
lock screw
Impeller
clamping
nut
Grille
tightening
nut
Motor axle pin
Motor shaft
Positioning
pins
Plastic disk