4
05/2018 Subject to technical changes.
domat UX0
…
Type table
Type
LCD
5 buttons DI
DO
t
rH
RTC
UX011
✓
✓
1
3
✓
UX015
✓
✓
1
3
✓
✓
UX041
✓
✓
1
3
✓
✓
UX045
✓
✓
1
3
✓
✓
✓
RTC... real time clock
Process control algorithms (evaluation of the temperature sensor and digital input DI1,
activating of the DO1 output by increased / decreased temperature, humidity etc.) and
central sunblind override must be implemented in the master controller.
Dimensions
All dimensions in
mm
.
Installation
Units are intended for operating in a normal and chemically non-aggressive
environment. They do not need any servicing or maintenance. Install them in a vertical
position at places where they can be operated easily and measure correct values of
temperature and humidity, i.e. in the height of about 150 cm, with no direct sunlight or
other heat / cool source (AHU outlets, refridgerator, electrical appliances). The device
consists of two parts: bottom with screw terminal block and cover containing PCB,
display, and the knob. The bottom part is fixed by 2 or 4 screws to any flat surface or a
flush-
mounting box Ø 50 mm. At the back of the bottom there is an aperture for cabling.
The bottom should be installed and cabling connected first, and the upper part inserted
after the construction works have been finished to prevent damage to the unit.
