Switch Polarization Print HPP4 │ version 2 – 2019
Page:
8 van 11
Configuring the OC32
After connecting you still must tell the OC32 that a relay is connected to pin output x. This way, the OC32
can also control the relay.
First you open OCConfig, we assume that the OC General tab according to the OC32 manual is already
set. If not, do so first before continuing here. The "hardware configuration" is very important. If that is
done, then you go to the relevant pin. For the sake of convenience, we call the relevant pin 1.
As the device definition, load the (1) GEN; On / Off. After selecting, click on Load Device and you will see
the screen below, but you must check the box "show details":
