Page 10
Door/Window Sensor Advanced User Manual
Physical Installation
Installation Using Double-Stick Tape
1. Wipe the door and door-frame clean of dust and anything else that will
interfere with the tape’s stickiness.
2. Peel the double-stick tape and adhere the Sensor Assembly to the door
surface.
3. Repeat the process for the Magnet Assembly, making sure the
Magnet Assembly, and Sensor Assembly are no more than 1-1/4” apart when
closed. The lines on the sides of the Magnet Assembly, and Sensor Assembly
should be in line.
4. Open and close the door to make sure the sensor works as expected (the
LED Indicator blinks) and that the signal reaches your Z-Wave controller.
Installation Using Screws
1. Remove the Sensor Cover and Battery from the Sensor Base and the
Magnet Cover from the Magnet Base.
2. Hold the Sensor Base in place and drive the included screws through the
screw holes into the door.
3. Repeat the process for the
Magnet Assembly, making sure the
Magnet Assembly, and Sensor Assembly
are no more than 1-1/4” apart when the
door is closed. The lines on the sides of the
MAGNET and SENSOR should be in line.
4. Replace the Battery, Sensor Cover, and
Magnet Cover.
5. Open and close the door to make sure the
sensor works as expected (the LED Indicator
blinks) and that the signal reaches your
Z-Wave controller.
SolidWorks Student Edition.
For Academic Use Only.
Figure 4 - Screw Alignment
