Page 8
Door/Window Sensor Advanced User Manual
Inclusion & Exclusion
Resetting the Door/Window Sensor
If needed, the Door/Window Sensor can be reset locally by following these
steps.
Only do this if your Z-Wave controller is missing or otherwise un-
reachable.
Beware that resetting your device will disconnect it from the
system:
1. Remove the Sensor Cover and confirm that your Door/Window Sensor is
powered up.
2. Wait for 5 seconds.
3. Move the Magnet and Sensor Base in and out of the closed position 6
times.
4. The LED Indicator will light up red for five seconds when reset successfully.
The Door/Window Sensor’s memory will be erased to factory settings.
Waking Up The Door/Window Sensor
Because the Door/Window Sensor is a battery powered device, it wakes up on
regular intervals to give battery and other status updates to the controller, as
well as to accept configuration settings from the controller. This helps to extend
the battery life. The Sensor Cover holds down the Button when installed, and
the device can be forced to wake up to submit reports or accept new settings
immediately by simply
removing the Sensor Cover and then replacing it after.
If
the device is already included in a system, the LED Indicator will flash Red until
the cover is closed.
