Page 8 of 14
•
Fill Upper water tank with clean cold water.
•
As a reminder of when to change and replace the
filter, lift and turn the dial on the lid to the current
month. The Filter Replacement month will show
the second successive month from the start date.
•
Place the lid on the Upper water tank.
•
Let the water filter through into the lower water tank and continue to refill
the top water tank until both the top and lower water tanks are full.
Note
: It is recommended that after the filter has finished soaking, been
rinsed and then fitted to the chiller unit, fill the chiller tank and operate the
taps to allow all the water to flush through and to remove any remaining
black dust. Repeat a second time. The discarded water can be used on
your plants without harm. This will happen on all new filters and when
water is filtered through it the first couple of uses. This is no cause for
alarm. It is just the dust from the activated carbon inside the filter. Although
it looks unsightly, will not harm you.
5 Instructions For Use
•
Insert the plug into a power socket and switch
on.
•
Switch the Water Chiller to “ON” at the back of
the unit.
•
Both the Blue “Cold” and Yellow “Power” indicator lights will illuminate
indicating there is power supplied to the unit, and that the water chiller is
chilling the water.
