EN
CFX75DZW, CFX95DZW
Operation
17
The battery monitor mode can be selected as follows:
➤
Switch on the cooler.
➤
Press the “SET” button (fig.
3
4, page 3) four times.
➤
Use the “UP +” (fig.
3
10, page 3) or “DOWN –” (fig.
3
9, page 3) buttons to
select the battery monitor mode.
✓
Digital display will be as follows:
Lo (LOW),
Π
d (MED), HI (HIGH)
✓
The selected mode then appears in the display for a few seconds. The display
flashes several times before it returns to the current temperature.
I
7.5
Using the cooler
A
➤
Place the cooler on a firm foundation.
Make sure that the ventilation slots are not covered and that the heated air can
dissipate.
I
➤
Connect the cooler, see chapter “Connecting the cooler” on page 15.
A
NOTE
When the cooler is supplied by the starter battery, select the battery
monitor mode “HIGH”. If the cooler is connected to a supply battery,
the battery monitor mode “LOW” will suffice.
NOTICE! Danger of overheating!
Ensure at all times that there is sufficient ventilation so that the heat that
generated during operation can dissipate. Ensure that the ventilation
slots are not covered. Make sure that the device is sufficiently far away
from walls and other objects so that the air can circulate.
NOTE
Place the cooler as shown (fig.
1
, page 3). If you operate the box in a
different orientation it can be damaged.
NOTICE! Danger from excessively low temperature!
Ensure that the only those objects are placed in the cooler that are
intended to be cooled at the selected temperature.
CFX75_95DZW--O-US.book Seite 17 Montag, 3. April 2017 5:10 17
