EN
Cleaning and maintenance
CF 35, CF40, CF50
20
➤
Re-assemble the plug in the reverse order.
I
6.11
Replacing the light bulb
➤
Press the switch pin (fig.
2, page 5) downwards so that the transparent part
1, page 5) of the lamp can be removed at the front.
➤
Replace the light bulb.
I
➤
Press the transparent part of the lamp back into the housing.
7
Cleaning and maintenance
A
➤
Occasionally clean the device interior and exterior with a damp cloth.
➤
Make sure that the air inlet and outlet vents on the device are free of any dust and
dirt, so that heat can be released and the device is not damaged.
NOTE – Internal DC fuse
There is an additional DC fuse inside the device (Automotive standard
blade fuse, 10 A). This fuse can only be replaced by an authorised repair
centre.
NOTE
The LEDs in the light bulb must be aligned with the transparent part of
the lamp.
NOTICE! Damage hazard
•
Never clean the cooler under running water or in dish water.
•
Do not use abrasive cleaning agents or hard objects during cleaning
as these can damage the cooler.
DometicCF35-CF50_OPM4445101783_EMEA16_202x-xx-xx.book Seite 20 Freitag, 18. Dezember 2020 5:37 17