EN
Troubleshooting
HiPro
18
Poor cooling perfor-
mance
Cooling unit not sufficiently ventilated
➤
Provide sufficient ven-
tilation, see Installa-
tion Manual
Minibar exposed to direct sunlight
➤
Take minibar out of
direct sunlight
Door of minibar not closed with a
tight seal
➤
Check distances, see
Installation Manual
➤
Contact service
agent.
➤
Service agent:
Replace door seal
Minibar recently filled
➤
Check cooling again
after 5 to 6 hours
For versions with absorber cool-
ing:
The input voltage is too low or
high.
➤
Check input voltage
Frost formation in the
minibar compartment
Door of minibar not closed with a
tight seal
➤
Check distances, see
Installation Manual
➤
Contact service
agent.
➤
Service agent:
Replace door seal
Interior lighting not
working
Power plug not plugged in
➤
Insert power plug into
socket
Interior lighting is defective
➤
Contact service
agent.
➤
Service agent:
Change interior light-
ing
Surface of infrared door sensor is cov-
ered by condensate water
➤
Clean the surface of
the infrared door sen-
sor
Fault
Possible cause
Solution
DometicHiPro30-40_OPM_4445103223_AMER4_xxxx-xx-xx.book Page 18 Tuesday, September 13, 2022 10:48 AM