background image

3

Power Patio Awning User’s Guide

To Adjust The Awning Pitch:

1.  With awning fully extended, loosen knob on bot-

tom arm.

Pinch  Hazzard.  When  adjusting  awning 
pitch, bottom arm will telescope. Keep hands 
and  objects  clear  of  openings  around  bot-
tom arm. Failure to heed this warning could 
cause personal injury.

2.  Pull top arm down to lower roller tube to desired 

height.

3.  While  holding  top  arm  in  place,  tighten  knob  to 

set pitch.

4.  Repeat for hardware on other side.

Pinch 
Point

Pinch 
Point

 

1.  Remote Rocker Switch

a.  Press and hold the “Retract” but-

ton  to  automatically  close  aw-
ning. If the button is released the 
awning will stop. Maintain button 
depressed until awning is fully re-
tracted, then release.

Important:

 As  an  extra  safety  precaution,  visually 

verify that the awning is fully closed.

Pull Top 

Arm Down

Then 

Tighten 

Knob

FIG. 2

FIG. 3

FIG. 4

Important:

 To ensure rain water will run off awning, 

ensure that one end of the awning is lower than the 
other end. This will reduce the potential for water pool-
ing in the center of the awning. See FIG. 4.

5.  Prior to closing awning, loosen knob to allow aw-

ning  to  reset  to  original  position.  Lightly  tighten 
knob  to  reduce  potential  for  sounds  of  rattling 
during travel.

In Case Of  Awning Power Failure Or To 

Manually Close Awning:

Important:

 

This procedure will require two people. 

When this procedure has been performed, the awning 
must  be  serviced  by  a  Dometic  Service  Center  or  a 

qualified service technician before using again. 

There are two methods of rolling up the 

awning if it appears there is no power to 
the awning motor.  The following method 

should be performed first:

1. 

When the Power Awning hardware is in the open 
position and the 12 VDC power has been lost the 
awning can be closed by supplying auxiliary pow-
er to the hardware. Connect the awning motor to 
an external 12 VDC power source via user-sup-
plied wire (16 gauge minimum). A good external 
12  VDC  power  source  would  be  an  automobile 
battery.

To Close Awning:

Pinch Hazard. When closing awning, bottom 
arm  will  fold  down  and  against  back  chan-
nel. This area must be kept clear of people 
and  objects.  Failure  to  heed  this  warning 
could  cause  severe  personal  injury  and/or 
property damage.

More information https://www.caravansplus.com.au

Summary of Contents for A&E 895 Series

Page 1: ... OFFICE Dometic LLC 2320 Industrial Parkway Elkhart IN 46516 574 294 2511 CANADA Dometic LLC 46 Zatonski Unit 3 Brantford ON N3T 5L8 CANADA 519 720 9578 For Service Center Assistance Call 800 544 4881 User s Guide Power Patio Awning Model s 895 X 0 X X 400 X More information https www caravansplus com au ...

Page 2: ...SAFETY INSTRUCTIONS This manual has safety information and instruc tions to help users eliminate or reduce the risk of accidents and injuries RECOGNIZE SAFETY INFORMATION This is the safety alert symbol When you see this symbol in this manual be alert to the potential for personal injury Follow recommended precautions and safe op erating instructions UNDERSTAND SIGNAL WORDS Asignal word WARNING OR...

Page 3: ...r of the awning See FIG 4 5 Prior to closing awning loosen knob to allow aw ning to reset to original position Lightly tighten knob to reduce potential for sounds of rattling during travel In Case Of Awning Power Failure Or To Manually Close Awning Important This procedure will require two people When this procedure has been performed the awning must be serviced by a Dometic Service Center or a qu...

Page 4: ...ng until service requirements have been completed 2 Locate and unplug the motor and hardware cable connection located in the upper part of the right hand arm 3 Connect the user supplied wire leads to the ter minals in the connector from the motor Electrical tape may be required to keep the wire leads in place Do not connect to the one in the hard ware 4 Connect the other end to a 12 VDC battery so...

Reviews: