EN
CC32, CC40 AC/DC
Operation
13
In “HIGH” mode, the battery monitor responds faster than at the levels “LOW” and
“MED” (see the following table).
Proceed as follows to select the battery monitor mode:
➤
Switch on the cooling device.
➤
Press the “SET” button three times.
➤
Use the “+” and “–” buttons to select the battery monitor mode.
✓
The selected mode then appears in the display for a few seconds. The display
flashes several times before it returns to the current temperature.
I
6.5
Using the cooling device
A
➤
Place the cooling device on a firm foundation.
I
➤
Connect the cooling device, see chapter “Connecting the cooling device” on
page 12.
Battery monitor mode
LOW
MED
HIGH
Switch-off voltage at 12 V
10.1 V
11.4 V
11.8 V
Restartvoltage at 12 V
11.1 V
12.2 V
12.6 V
Switch-off voltage at 24 V
21.5 V
24.1 V
24.6 V
Restart voltage at 24 V
23.0 V
25.3 V
26.2 V
NOTE
When the cooling device is supplied by the vehicle battery, select the
battery monitor mode “HIGH”. If the cooling device is connected to a
supply battery, the battery monitor mode “LOW” will suffice.
NOTICE! Danger of overheating!
Ensure at all times that there is sufficient ventilation so that the heat that
generated during operation can dissipate. Ensure that the ventilation
slots are not covered. Make sure that the cooling device is sufficiently far
away from walls and other objects so that the air can circulate.
NOTE
Place the cooling device as shown (fig.
1
, page 2). If you operate the
cooling device in a different position it can be damaged.
CC40US-B-US.book Seite 13 Freitag, 20. Oktober 2017 10:13 10
