EN
Operation
CFX100
20
I
2. Connect the cooling box, see chapter “Connecting the cooling box” on
A
3. Press the “ON/OFF” button (fig.
1, page 4) for between one and two
seconds.
✔
The LED “
P
” lights up (fig.
✔
The display (fig.
5, page 4) switches on and shows the current temperature.
✔
The cooling box starts cooling the interior.
I
Latching the cooling box lid
1. Close the lid.
2. Press the latches (fig.
1, page 3) down, until they latch in place audibly.
I
7.6
Setting the temperature
1. Press the “SET” button (fig.
4, page 4) once.
2. Use the “UP +” (fig.
7, page 4) and “DOWN –” (fig.
6, page 4) buttons to
select the cooling temperature.
✔
The cooling temperature appears in the display for a few seconds. The display
flashes several times and then the current temperature is displayed again.
NOTE
Place the cooling box as shown (fig.
, page 3). If you operate the
cooling box in a different orientation it can be damaged.
NOTICE! Hazard from excessively low temperature
Ensure that only those objects are placed in the cooling box that are
intended to be cooled at the selected temperature.
NOTE
When operating with the battery, the display switches off automatically
if the battery voltage is low. The LED “
P
” flashes orange.
NOTE – “Lid open” alarm
If the lid is left open for three minutes or more and the device is switched
on, the interior light will flash until the lid is closed.
DometicCFX100Professional_OPM_4445103658_EMEA16_20xx-xx-xx.book Seite 20 Montag, 3. Januar 2022 4:13 16
