EN
CFX100
Operation
21
I
7.7
Set brightness of display
The display brightness can be dimmed for low ambient light conditions. To set the
dimming level of the display proceed as follows:
1. Switch on the cooling box.
2. Press the “SET” button (fig.
4, page 4) four times.
3. Use the “UP +” (fig.
7, page 4) or “DOWN –” (fig.
set the brightness of the display.
✔
Display will be as follows:
d0 (default), d1 (medium), d2 (dark)
✔
The display shows the set mode for some seconds. The display flashes several
times before it returns to the current brightness.
I
7.8
Using the emergency switch
The emergency switch (fig.
3, page 4) is located below the control panel. For
normal operation the switch is in the “NORMAL USE” position.
➤
If an electronic control failure occurs, slide the switch to “EMERGENCY
OVERRIDE” position
I
NOTE
The temperature of each compartment can be set to –22 °C. The
manufacturer however recommends a cooling temperature of –15 °C to
–18 °C for normal usage and optimum energy consumption.
NOTE
•
The factory setting of brightness of the display is d0 (default).
•
If a fault occurs, the brightness automatically is d0 (default). After
troubleshooting the set brightness is reactivated.
NOTE
If the switch is in the “EMERGENCY OVERRIDE” position, the cooling
box runs with full cooling capacity and may freeze.
DometicCFX100Professional_OPM_4445103658_EMEA16_20xx-xx-xx.book Seite 21 Montag, 3. Januar 2022 4:13 16
