EN
CD20, CD30
Safety instructions
9
•
Disconnect the cooler and other power consuming devices from the
battery before connecting the quick charging device.
•
Disconnect the cooler or switch it off when you turn off the engine.
Otherwise you may discharge the battery.
•
The cooling device is not suitable for transporting caustic materials or
materials containing solvents.
•
The cooling device contains inflammable cyclopentane in the
insulation. The gases in the insulation material require special disposal
procedures. Deliver the device at the end of its life-cycle to an appro-
priate recycling.
2.2
Operating the device safely
!
CAUTION!
•
Before starting the device, ensure that the power supply line and the
plug are dry.
A
NOTICE!
•
Do not use electrical devices inside the cooler unless they are
recommended by the manufacturer for the purpose.
•
Do not place the device near naked flames or other heat sources
(heaters, direct sunlight, gas ovens etc.).
•
Danger of overheating!
Ensure at all times that there is sufficient ventilation so that the heat that
arises during operation does not build up. Make sure that the device
is sufficiently far away from walls and other objects so that the air can
circulate.
•
Ensure that the ventilation openings are not covered.
•
Do not fill the inner container with ice or fluid.
•
Never immerse the device in water.
•
Protect the device and the cable against heat and moisture.
•
For HGV operation:
Empty the coolbox and switch the device off (see chapter “Switching
off the coolbox” on page 13), before the driver's cabin is tipped up.
CD20-30-IO-US.book Seite 9 Montag, 29. Mai 2017 4:41 16
