EN
Setting up and connecting the refrigerator
CRP40
14
7
Setting up and connecting the
refrigerator
!
7.1
Installing the refrigerator
A
.
WARNING! Safety instructions for installation on boats
Please note the following instructions for installation on boats:
•
The refrigerator is designed for short-term heeling of up to 30°.
When setting up the refrigerator, note that it must be fastened to take
account of this. If you have any questions regarding installation, con-
sult your specialist dealer.
•
Install the refrigerator so that the warm air produced can easily flow
away (either upwards or to the sides, fig.
•
If the refrigerator is powered by the mains, ensure that the power
supply has a residual current circuit breaker.
•
Observe all the other installation instructions in this section.
NOTICE! Damage hazard
•
Do not place the refrigerator near naked flames or other heat sources
(heaters, direct sunlight, gas ovens etc.).
•
Place the refrigerator in a dry, sheltered place (installation
dimensions:fig.
•
Never immerse the refrigerator in water.
•
Protect the refrigerator and the cable against heat and moisture.
•
In continuous operation, the air humidity may not exceed 90 %.
•
The refrigerator must be positioned so that heated air can dissipate
easily. Therefore make sure there is adequate ventilation (fig.
No. in fig.
Explanation
1
Hot waste air
2
Cold intake air
3
Condenser
4
With decorative panel 50 mm space at the top!
Summary of Contents for CoolMatic CRP 40S
