EN
CRX50 Pro, CRX65 Pro
Safety instructions
13
!
CAUTION! Failure to obey these cautions could result in minor or
moderate injury.
Electrocution hazard
•
Before starting the device, ensure that the power supply line and the
plug are dry.
Health hazard
•
Opening the door for long periods can cause significant increase of
the temperature in the compartments of the device.
•
Clean regularly surfaces that can come in contact with food and
accessible drainage systems.
•
Store raw meat and fish in suitable containers in the device, so that it is
not in contact with or can drip onto other food.
•
If the device is left empty for long periods:
–
Switch off the device.
–
Defrost the device.
–
Clean and dry the device.
–
Leave the door open to prevent mould developing within the
device.
A
NOTICE! Damage hazard
•
Do not use electrical devices inside the cooling device unless they are
recommended by the manufacturer for that purpose.
•
Do not place it near naked flames or other heat sources (heaters, direct
sunlight, gas ovens etc.)
•
Danger of overheating!
Always ensure sufficient ventilation so that the heat generated during
operation can dissipate. Make sure that the device is sufficiently far
away from walls and other objects so that the air can circulate.
•
Ensure that the ventilation vents are not covered.
•
Do not fill the inner container with ice or fluid.
•
Never immerse the device in water.
•
Protect the device and the cable against heat and moisture.
•
Make sure that foodstuffs do not touch the walls of the cooling area.
•
The use of a load dump board is mandatory on all Semi Truck
12 V or 24 V DC applications. Ensure that the load dump board and
the control module are always replaced together.
