EN
Operation
DM 50NTE D, DM 50NTE F, DM 50NTE UPOE
20
Drilling the holes (fig.
1. Drill a hole (
A 1
) with a diameter of 23.6 mm (0.93 in) through the decor (only
DM50NTE D) and the door.
2. Unscrew the twelve screws (
B 1
) of the decor frame (
B 2
) (only DM50NTE D).
3. Remove the decor frame (only DM50NTE D).
Assembling the lock (fig.
1. Put the new lock cover (
A 1
) into place.
2. Put the decor (
B 1
) into the decor frame.
3. Screw (
B 2
) the decor frame (
B 3
) onto the door.
4. Install the door lock (
C 1
).
5. Install the lock catch (
D 1
) in the cabinet.
Assembling the drawer (fig.
1. Push the gasket (
1
) on the decor frame (
2
).
2. Screw the door handle (
4
) onto the door.
3. Push the plugs (
3
) on the screws of the door handle (
4
).
4. Push the drawer into the cabinet.
7
Operation
7.1
Saving energy
•
Only open the minibar as often and for as long as necessary.
•
Avoid unnecessarily low temperature settings.
•
For optimal energy consumption, position the shelves and drawers according to
their position on delivery.
•
On a regularly basis, make sure the door seal still fits properly.
•
Clean dust and dirt from the condenser at regular intervals.
7.2
Using the minibar
The minibar starts cooling when connected to power. During normal operation the
Power Status LED is glowing. If an error occurs the Error LED is blinking (see chapter
“Troubleshooting” on page 22).
DometicDM50NTE-UPOE_IOM_4445103432_AMER4_202x-xx-xx.book Seite 20 Dienstag, 7. Dezember 2021 7:52 07
