Dometic DM2672, Operating Manual

7

EN

 Refrigerator

Gas mode

•  This mode provides LP gas only.
•  The control system activates the ignition system and attempts to light the burner for about 45 seconds.

•  DM2672, DMA4061, DM2872, DMA4081:

When operating in GAS mode, the AUTO mode lamp will 

be off.

•  If the burner fails to ignite, the CHECK indicator lamp will flash on and off, and a buzzer will beep.

➤

Restart the refrigerator if the CHECK indicator lamp is flashing and the buzzer is beeping. The CHECK 
indicator lamp and buzzer will not turn off until the refrigerator is restarted, even if AC becomes available.

Limp mode

•  If a major operating component fails, the control system will continue operating the cooling system.

I

DM2672, DMA4061, DM2872, DMA4081:

•  The control will run the cooling unit continuously if it cannot read the temperature sensor.
•  The refrigerator will continue operating in this mode indefinitely, or until a new sensor is installed and the 

system is reset.

I

DM2682, DM2683, DMA4064, DMA4067, DMA4068, DM2882, DMA4084, DMA4087: 

•  If the display module becomes nonfunctional:

– The control system reverts to full automatic operation.

– The temperature setting is maintained at the middle position.

– The power module will continue to re-establish operation of the display module.

•  If the temperature sensor fails:

– The control system operates on the energy source selected on the control panel.

– The cooling unit runs continuously.

– The refrigerator will continue to operate in this mode indefinitely, or until a new sensor is installed and the 

system is reset.

3.3  Understanding the storage compartments

Food storage

I

Read 

before

 proceeding:

•  The food storage compartment should remain closed to maintain the required temperature.
•  The coldest locations in the refrigerator are under the cooling fins and at the bottom of the refrigerator.
•  The warmest locations in the refrigerator are on the upper door shelves.

➤

Cover foods to maintain freshness.

➤

Allow the refrigerator to cool before placing food inside.

➤

Allow hot drinks or food to cool to room temperature before placing them inside the refrigerator.

➤

Arrange foods in the refrigerator to allow for free air circulation. Do 

not

 overstock the refrigerator.

➤

Ensure that the refrigerator door is not left open longer than necessary. This will reduce frost formation and 
maintain the efficiency of the refrigerator

Frozen food storage

I

The frozen food storage compartment is not designed for deep- or quick-freezing food.

➤

Cover foods to prevent them from drying out.

➤

Place quick frozen fruits and ice cream at the bottom of the aluminum liner.