EN
DoorLock DM100, DP100
Fitting the door lock
32
9
Fitting the door lock
9.1
Preparing the door leaf
I
➤
Drill the holes and prepare the recesses for the door lock:
–
DM100
: fig.
2
, page 4 and fig.
4
, page 6.
–
DP100
: fig.
3
, page 5 and fig.
4
, page 6.
➤
Clean the recess for the lock and all drill holes by blowing out or vacuum-
ing any debris.
9.2
Fitting the door lock
➤
Guide the mortice lock data cable upwards through the recess.
➤
Affix the mortice lock (fig.
5
1.
, page 7) with two screws in the recess for
the lock.
➤
Fit the outer door handle with the corresponding spindle (fig.
5
2.
,
page 7).
➤
DP 100 only
: Connect the wide data cable to the outer door handle.
➤
Fit the inner door handle with the corresponding spindle and affix it with
three screws (fig.
5
3.
, page 7).
➤
Fit the profile cylinder (fig.
5
4.
, page 7).
➤
Fix the profile cylinder into place with the faceplate screw (fig.
5
5.
,
page 7).
➤
Connect the required data cables to the control unit.
➤
Disconnect the cable for the power supply from the control unit (fig.
6
3.
,
page 8).
➤
Insert four new AA batteries into the battery compartment (fig.
6
5.
,
page 8).
➤
Connect the cable for the power supply to the control unit (fig.
6
6.
,
page 8).
➤
Replace the battery compartment cover (fig.
6
7.
, page 8).
➤
Affix the battery compartment with the screw (fig.
6
8.
, page 8).
NOTE
The door leaf must have a depth of at least 35
mm.
Summary of Contents for DoorLock DM100
