27
EN
Frigo DC
Installing the transport refrigeration system
•
Never lay power supply lines (battery leads) in the vicinity of signal or control
wires.
•
For safety reasons, note the location of existing wiring harnesses, wires and
other components within the installation area, in particular those which are
not visible, when installing the transport refrigeration system (when drilling or
screwing etc.).
•
Treat drill holes and cut edges with a corrosion inhibitor.
•
Cover plastic piping and brake hoses before drilling or remove these if nec-
essary.
•
Lay the electric cables so that they are a distance of at least 15 mm away from
rotating parts and at least 150 mm away from parts of the vehicle which
become very hot.
•
Do not attach any cables, electrical wiring or hose lines to the hoses of the
brake system.
•
Lay all hose lines and electrical wiring in such a way that they are free of
mechanical loads.
•
Fasten the cable sets with cable binders and hose clips.
•
Join the compact plug connections so that snap-in points are fixed.
•
During the assembly of the watertight plug housing ensure that the rubber
seals for the cables and plug housing are present.
•
In areas at high-risk of splashing (e.g. engine compartment, underbody), pro-
tect plug connections that are not watertight with an additional protective
wax spray, insulating tape or similar. Corrosion on the plug connections can
cause failure of the transport refrigeration system.
•
Ensure that the subsequently fitted fuse box is installed outside of the areas
exposed to splashing. Maintain a distance of at least 30 mm from fluid cir-
cuits. A distance of 300 mm must be maintained between fuse boxes and
flammable liquids (fuel filter, tank etc.).
•
Install the fuse box as close as possible to the battery.
•
Do not connect any additional power consuming devices to the assigned
fuses.
•
Do not attach any additional cables (e.g. insulation-displacement connector)
to the existing cable lines.
Frigo_DC-I-West.book Seite 27 Mittwoch, 24. Juni 2020 11:27 11
Summary of Contents for Frigo DC 2500
Page 9: ...Frigo DC 8 A C D E F G B d Frigo_DC I West book Seite 8 Mittwoch 24 Juni 2020 11 27 11...
Page 12: ...11 Frigo DC h 80 mm i Frigo_DC I West book Seite 11 Mittwoch 24 Juni 2020 11 27 11...
Page 13: ...Frigo DC 12 2 1 j 2 3 1 4 k Frigo_DC I West book Seite 12 Mittwoch 24 Juni 2020 11 27 11...
Page 15: ...Frigo DC 14 A B n 2 3 1 o Frigo_DC I West book Seite 14 Mittwoch 24 Juni 2020 11 27 11...
