EN
Using the refrigerator
HiPro
24
➤
Press the yellow button (3) to set the cooling temperature to 3 °C or 7 °C.
✓
The LEDs of the interior light (5) flash three times or seven times, respectively, to
display the preset temperature (fig.
i
, page 12).
➤
Press the blue button (4) to set the cooling temperature to 5 °C or 12 °C.
✓
The LEDs of the interior light (5) flash five times or twelve times, respectively, to
display the preset temperature (fig.
i
, page 12).
I
8
8.6
Using the door opening monitor
The door opening monitor (optional) displays via an LED (fig.
1
4,page 2) whether
the refrigerator door has been opened.
If the door opening monitor LED illuminates:
➤
Open the refrigerator.
➤
If necessary, refill the refrigerator.
➤
Reset the door opening monitor with the remote control (optional). To do this,
press the red button once (fig.
i
1, page 12).
➤
Close the refrigerator.
8.7
Defrosting the cooling device
The refrigerator is equipped with an automatic defrosting function.
The defrosting phase takes place every 22 hours for a duration of 2 hours.
I
8.8
Switching off and storing the refrigerator
If you do not intend to use the refrigerator for a long time, proceed as follows:
➤
Pull the power plug out of the socket.
➤
Clean the refrigerator (see chapter “Cleaning and care” on page 25).
NOTE
The red LED illuminates as soon as a signal has been sent out. Check the
batteries if the LED does not illuminate.
NOTE
The first defrosting phase starts 39 hours after the refrigerator has been
switched on. Start-up during the day ensures that the defrosting phases
occur during nighttime hours.
HiPro3000_4000_6000_Vision-IO-16s.book Seite 24 Dienstag, 27. November 2018 4:24 16
