EN
HiPro
Cleaning and care
25
9
Cleaning and care
A
➤
Disconnect the device from the mains supply prior to cleaning and maintaining it.
➤
Clean the refrigerator with a soft cloth and lukewarm water. Use a mild cleanser.
➤
Rinse the refrigerator after cleaning with clear water.
➤
Finally, wipe the refrigerator dry with a cloth.
➤
Use a brush or soft cloth to remove dust from the absorber unit on a yearly basis.
10
Troubleshooting
NOTICE! Risk of damage!
•
Clean the refrigerator regularly and as soon as it becomes dirty.
•
Do not use any soap or strong, grainy or alkaline cleaning agents.
•
Do not use any hard implements for cleaning.
•
Do not use hard or pointed tools to speed up the defrosting process.
•
Make sure that no water drips into the seals. This can damage the
electronics.
•
Do not allow grease or oil to come into contact with the door seal.
•
Do not re-lubricate the cylinder locks (optional). The cylinder locks
have been permanently lubricated at the factory.
Fault
Possible cause
Solution
No cooling, absorber
unit cold
Power plug not plugged in
Insert power plug in
socket
No voltage in socket
Check household fuse
Electronics or sensors defective
Authorized service: Install
new electronics or sensor
Heating cartridge defective
Authorized service:
Install new heating car-
tridge
Defrosting phase active (see chapter
“Defrosting the cooling device” on
page 24)
No action required
HiPro3000_4000_6000_Vision-IO-16s.book Seite 25 Dienstag, 27. November 2018 4:24 16
