6
IMPORTANT
First make sure that the appliance has not been damaged in transit. If any
damage has been incurred, please inform the supplier immediately.
Please read these instructions carefully.
Keep the instructions in a safe place and make sure that they are retained
with the refrigerator when the appliance is transferred to a new location or
owner.
Note!
If this refrigerator is replacing a larger one which is going to be
scrapped, remove the door before disposal to prevent children from
becoming trapped inside.
Please contact the relevant area refuse office to arrange disposal. The pipe
system of your refrigerator must not be damaged if technically correct to the
recycling centre for your area.
Recommendation:
before installation or initial use of the appliance, clean
the interior and fittings with lukewarm water and, if necessary, a mild
detergent. Never use acidic, abrasive or strong-smelling detergents or wax
polishes!
INSTALLATION INSTRUCTIONS
The refrigerator is equipped with an absorber unit wich is completely silent
in operation.
It is designed for free-standing installation but can be built in if the following
instructions are observed.
In order to ensure perfect operation and maximum cooling efficiency of the
appliance, the following conditions must be stricitly complied with:
1)
sufficient supply of fresh air from below;
2)
good heat dissipation above the cooling unit, free from obstruction;
3)
stable, level position of the refrigerator;
If the appliance is to be built in, please ensure that it can be removed if
necessary without damaging the surrounding fitments.
The refrigerator must be positioned far enough into the fitment for the entire
unit to project into the air duct. Ventilation must not be obstructed by a
radiator, television or any source of heat.
Two refrigerators should not be built in, one on top of the other, unless
separate ventilation is provided for each.
