background image

7

Below are several possibilities for building  in the refrigerator, whereby the

dimensions given are minimum dimensions.
If built into an open shelf, fig. 2, it is sufficient for the air duct to be 105 mm

deep. This can be achieved by attaching 105 mm spacers to the rear panel

of the shelf (not supplied). The entire unit must nevertheless project into the

air duct.
If  built  into  a  wall  cupboard,  fig.  3-5,  the  air  duct  must  correspond  to  the

width of the refrigerator and measure at least 105 mm above and behind the

refrigerator. If decorative grilles are used, the open ventilation section per

grille must measure at least 200 cm

2

.

Door hang and decorative door panel

The  position  you  select  for  your  refrigerator  may  make  it  necessary  to

reverse  the  door  hang.  If  this  is  the  case,  please  read:  Reversing  the

doorhang.
The decorative panel on this appliance can be replaced. With regard to this

please read: Changing the decorative door panel.

Connecting to the mains

The appliance must only be connected to the mains by means of an earthed

socket wich has been installed in accordance with the regulations. Before

connecting up, check that the voltage on the data label ( in the top left of the

inside compartment ) is compatible with the mains supply.

SWITCHING ON

To switch on the refrigerator, plug it into the socket and turn the termostat (in

the  inside  compartment)  to  position  3  or  4.  The  appliance  will  be  cool  in

about one hour.
The  temperature  inside  the  refrigerator  is  affected  by  location,  room

temperature  and  too  frequent  opening  of  the  door.  Adjustment  of  the

thermostat dial may therefore be necessary.

Temperature control

The cooling capacity can be adjusted by means of the termostat. 0 = cooling

is switched off, from 1-7 the temperature decreases. When the termostat is

at a medium setting (3 or 4) and the ambient temperature is normal, the

temperature inside the refrigerator is betwen 0°- 7 °C.
Note! Depending on the ambient temperature, service life, and quantity and

temperature of the refrigerated item, the temperature inside the refrigerator

can drop to below 0 °C when the thermostat is set at 7 (maximum cooling

capacity). Drinks can freeze, glass bottles and cans may burst!

Summary of Contents for miniCool EA 3140













Reviews: