PJS118
Using the appliance
EN
15
6.7
Starting Vehicles
The jump starter can be used to start vehicles with 12V batteries with up to 6L petrol or 4L diesel
engines.
I
➤
Open the socket (fig.
1).
➤
Connect the plug (fig.
3) of the intelligent battery clamp
to the socket (fig.
1).
➤
Switch On the device, following the instructions given in chapter “Starting and switching
on/off” on page 10.
A
No. in
Description
1
Socket for intelligent battery clamp
2
Intelligent battery clamp
3
Plug for intelligent battery clamp
4
Battery clamps (red/black)
NOTE
Ensure that the jump starter is no less than 50% charged.
If it is below 50%, it may not be able to jump start a vehicle.
NOTICE! MATERIAL DAMAGE.
• Once the vehicle is started, disconnect the clamps (fig.
4) from the vehicle‘s bat-
tery within 30 seconds (negative terminal on the vehicle‘s battery first).
• Do not connect the red and black clams together.
7
