RCD10.5XES
Installation
EN
15
8.4 Installation in a sealed location separate to the living space
It is recommended to install the refrigerator in a sealed location in order to prevent dust and heat from entering the
living space of the caravan or motor home.
!
1. Apply the included sealing strip to front of the bottom surface of the refrigerator (
1.
2. Push the refrigerator into position (
2.
in fig.
). This then seals the space behind the refrigerator to the interior
of the vehicle.
8.5 Installing the drain water hose
1. To avoid damage to the drain water hose, position the hole for the drain water hose in a way that the hose
does not kink.
2. Drill a hole through the vehicle floor at the rear of the refrigerator.
3. Install the drain water hose through the drilled hole. Ensure that the drain water hose is long enough in order to
drain the water outside of the vehicle.
DO NOT shorten the drain hose. The excess length will enable partial extraction of the refrigerator if required
for service access.
4. Ensure that the drain water hose is not kinked.
5. Seal the area around the drain water hose.
WARNING! Fire hazard
Do not use flammable materials such as silicone sealants, foam or similar for the draft-
proof installation.
1.
2.
5
Summary of Contents for RCD10.5XES
Page 30: ...Operation RCD10 5XES EN 30 4 5 3 CLICK CLICK 1 2 6 7 k...
Page 38: ......
Page 39: ......
