INSTALLATION
Unpacking
Check during unpacking that the device is defect-free.
Report transport damage to the transport company within 48 hours.
Check that the voltage noted on the model label corresponds to the
mains voltage.
Cleaning
Before operating the refrigerator, we recommend you clean it both inside
and outside.
Use a soft cloth, lukewarm water and a mild detergent.
Following this, wash out the refrigerator using clean water and dry
thoroughly.
At annual intervals, remove dust from fridge aggregate using a brush or
soft cloth.
W
WA
AR
RN
NIIN
NG
G::
To prevent material damage:
Do not use soap or detergents which are harsh, coarse or
which contain soda.
Keep the door seal free from oil and grease.
The cylinder locks have been lubricated in the factory to be long-lasting.
Installation
The RH303L has been especially desigend for freestanding or for
installation in kitchens.
Please take great care to observe the following points in order to
guarantee an optimal cooling performance and low energy consumption:
Do not place the refrigerator directly beside a heat source and do not
expose it to direct sunlight.
An unobstructed air circulation through the cooling aggregate must be
ensured.
The ventilation grid must not be covered, for example, by ornaments or
items of clothing.
The refrigerator must always be mounted
horizontally.
The following illustrations (A,B,C,D) show four different ways for installing
the refrigerator.
1 = ventilation grid
2 = air going in
3 = air coming out
Note:
The ventilation grids (1) must have a clear cross section of at
least
200cm
2
.
Minimum build-in dimensions (mm):
Height Width Thickness
757
529 555
4
4.1
4.2
4.0
4.3
