Dometic RM 23455, Installation And Operating Instructions Manual

14

MOUNTING INSTRUCTIONS

REPOSITIONING THE HINGES

The refrigerator is equipped with reversible doors. A special 

door reversing kit must be used to reverse the doors. This kit 

is delivered with RM 2350 but must be bought separately for  

RM 2455 and RM 2555 (part number 2932750-13/2) as well as 

for RM 4605 (part number 2932750-11/6). For further informa-

tion, please contact your dealer.

MOUNTING THE DOOR PANEL

Door panels are not supplied with the refrigerators and must be 

supplied by the manufacturer. This enables the manufacturer to 

match the door panel with the rest of the cabinetry inside the 

motor home or caravan. 
Before starting the mounting work, read the instructions thor-

oughly and check that the panel dimensions are in compliance 

with those given in the following table: 

Dimensions (mm)

Height

Width

Thickness max.

RM 2355

666±1

497±1

4

RM 2455

826±1

526±1

4

RM 2555

982±1

526±1

4

RM 4605

402±1  

(upper door)

525 ±1

4

826±1  

(lower door)

With screws 

(see Fig. 20 and Fig. 22)

To mount the door panel, follow these steps:  

Open the door 90 degrees.
On new refrigerators, the decoration strip is taped inside 

the door; if installed on the door, remove the door decora-

tion strip (2) by removing its three screws (1).
Remove the old panel. 
Insert the new panel by inserting the vertical edges into 

the grooves of the door frame (3). Then, push the panel 

downwards so that the lower horizontal edge of the panel 

(4) is fitted into the bottom grove (5).
Put the decoration strip across the door so that the gap is 

covered.
Secure the decoration strip with the three screws removed 

in step 2.

Snap in 

(see Fig. 21 and Fig. 22)

To mount the door panel, follow these steps:  

Open the door 90 degrees.
On new refrigerators, the decoration strip are taped inside 

the door; if installed on the door, remove the door decora-

tion strip (2) by gently pushing the four tabs away with a 

flat blade screwdriver (1).
Remove the old panel.
Insert the new panel by inserting the vertical edges into the 

grooves of the door frame (3).
Push the panel downward so that the lower horizontal edge 

of the panel (4) is fitted into the bottom grove (5).
Snap in the decoration strip (2).

1.
2.

3.
4.

5.

6.

1.
2.

3.
4.

5.

6.

1

1

1

2

1

1

1

With screws

Fig. 20

Snap in

1

2

2

Fig. 21

3

3

4

5

Fig. 22