SECTION
1
1 .1 RM2150 OPERATION
A.
1)
2)
3)
4)
5)
6)
GAS OPERATION
Set 12 volt switch to “OFF”.
Turn gas handle to left (so that handle is in
line with gas valve body).
Turn gas thermostat knob to #4 setting.
Press gas safety valve plunger up and hold.
Push piezo igniter plunger in repeatedly until
flame is observed at “6”.
When flame is lit:
1)
2)
3)
Discontinue pushing the piezo plunger.
BUT continue to hold up on the safety
valve plunger for about 15 seconds.
If flame goes out when plunger is re-
leased, repeat Steps 4 through 6.
TO SHUT GAS OPERATION OFF:
Turn handle (8) of the gas valve (5) away from
the back of the cabinet.
The refrigerator has a flame failure device which
will automatically shut off the gas to the burner if
the flame is blown out. While plunger (10) is
being held in, this device is temporarily inopera-
tive.
DANGER - DO NOT
hold this plunger in
unless attempting to light the gas burner.
B. ELECTRIC OPERATION
The refrigerator may be operated on 12 volt DC
only.
To
start electric operation:
1) Turn gas valve to “OFF” position - handle
pointed away from cabinet.
2) Switch the 12 volt DC toggle switch up to
“ON” position.
3) Turn the electric thermostat knob to #4.
C. REGULATION OF TEMPERATURE
With thermostat knob set at either # 3 or #4, the
cabinet will automatically maintain a suitable
temperature for ordinary food. Usually, no further
adjustment will be needed, but in hot weather, or
when more cooling is required, the knob may be
turned to a higher number. If less cooling is
required, turn the knob to a lower number.
3
