17
C A U T I O N : It is of great importance that the screwdriver is applied in front of
one of the plastic tongues which hold the inner panel and the door
front together.
3. Replace the sealing gasket round the inner panel and snap the inner panel and
the door front together.
4. Mount the evaporator door and refit its retainer.
Fig. 25
REPLACEMENT OF EVAPORATOR DOOR ON RM46, RM47, RM66, RM67
1.
2.
3.
4.
5.
Push the carrier (A) inwards by means of a blunt mandrel or pin (fig. 27)
and
remove the shutter.
Pry the spring housings (B fig. 27) away from the lining so that it snaps out
and turn the spring housings downwards
(fig. 28).
Mount the new shutter in close position first on one side, making sure that the
cross slots engage in the cross on the hinge plate (C fig. 27).
Press the carrier on the opposite side so that the hinge plate on the shutter
can be pushed over it. See that the crosses engage.
Turn the spring housings round and up until the small tag (A fig. 28) snaps
into the slot in the lining.
Fig. 2 7
Fig.
28
