33
THERMOSTAT REPLACEMENT
To replace the thermos tat, remove capillary from its clamp on the fresh food
evaporator fins, Remove the two sealing plugs, one on the outside and one on the
inside of the cabinet. Straighten the capillary and pull it through the cabinet,
Remove the thermostat by mscrewing it from the gas filter and the flame failure
safety device.
NOTE :
Always, shut off the gas supply before removing any gas part from the
r e f r i g e r a t o r ,
By-pass screw sizes and part No.
1
14
RM46
s17
s17
By-pass
screw
Part No.
34 19
17 28
17 28
17 28
17 28
couple
into flame)
THE GAS BURNER (see fig.
The burner has the jet horizontally
located and the burner mixing tube is
formed as a bend with vertical outlet.
The
air inlets are pre-set and
therefore not adjustable. The burner
and the burner holder are made in one
piece.
The burner is provided with the
electric failure safety device and the
thermocouple tip is pre-set.
Fig. 54
Fig. 55
To check for a correct flame, set thermostat to
Flame should have a bright
blue crown at the base of the
Burner jet sizes and input
Mode Butane Part
Propane
RM24 24 289 00
24
34 200 26
43
43 200 26
51
51 200 26
52
5 1 200 26
53
Part
Input BTU/h
600
26
1000
200 26
1100
200 36
1200
200
1360
