1.
Turn off the gas valve (C), its handle
then be pointing avay from the back
of the cabinet.
Turn the voltage change switch (A) to the required setting, then connect the
r e f r i g e r a t o r t o appropriate voltage supply,
When the electrical supply cord is connected to a 110 volt A.C. supply, tne
voltage on the switch (A) should show
when connected to
the
voltage on the switch (A) should show
3.
Turn the electric thermostat knob (E) to No. 4.
HOW TO START THE REFRIGERATOR
25.
RM47
RM67,
26.
GAS OPERATION (Fig. 72)
1.
To start the refrigerator turn the knob A to position
gas valve is
now opened and the electric circuits are disconnected.
2.
Turn the gas thermostat knob C to setting 4.
3.
Pull the knob D of the flame failure safety device and after 5-10 seconds press
the button E to the piezo lighter. The pressing may have to be repeated. Through
the reflector F it can be observed that the burner is lit.
4.
After the burner has been lit keep the knob in pulled out position for another
5 seconds. Then release the knob and check through the reflector
that
t h e
burner stays lit,
Note: After a replacement of the gas container or
shut-off period the
gas pipes are likely to be filled with air, In such a case the lighting
procedure has to be repeated until the air is pushed out of the pipes and
the gas has reached the burner.
27.
ELECTRIC OPERATION (Fig, 72)
1.
Check that the attachment plug of the flexible cord is
the main supply. The 12 volt connection is made at the
rear of the refrigerator.
2.
Turn the knob A to “off” position, then press the knob
desired electric position.
correctly connected co
marked terminals at the
in to bottom and turn to
