46
The Piezo lighter does not normally need any maintenance.
If by any reason the electrode or the lighter must be replaced, proceed as follows:
Replacement of electrode only.
1.
Unscrew burner outer shield.
2.
fastening screw “A” (Fig. 78) holding the electrode against side of
burner housing.
3.
Loosen the electrode from its cable by unscrewing the electrode anti-clockwise.
4.
Pit a new electrode,
CAUTION
When fastening the electrode on the burner housing make sure that the
insulation plate is properly fitted between the burner housing and
the electrode (see fig. 78).
Replacement of Piezo lighter complete
1.
Release the Piezo lighter knob
(see fig. 72)
pulling the knob outwards.
2.
Loosen outer burner shield and burner housing.
3.
Loosen the fastening screw “A” (Fig.
holding
burner housing.
4.
Loosen the
two
screws
on holder
Now the
pulled out at the rear of the cabinet.
5.
To fit new lighter, reverse above procedure.
inside the cabinet by means of
the electrode against side of
lighter complete can be
Electrode
Fig.
